Category Archives: Amplifiers

Robson MB2

Robson MB2

The MB2 monoblock amplifier is based around the legendary Hypex NCore 500 amplifier module and housed in a high end aluminium case and a touch of Robson class with either diamond engraved front panel or hardwood of your choice to match other products in our range.

Possibly the most accurate and detailed amplifier in the world with incredible dynamics and control and a perfect match for our all tube pre-amplifier MV1.

High current and damping factor the MB2 will drive the most difficult of loads with breath taking control and power.

Based around the MB1 in a more affordable cabinet and set of connectors.

PRICE - 500W -  £1600.00 /PAIR

PRICE - 250W -  £1300.00/PAIR

Specification

Output power

500W 4 ohms 270W 8 ohms NC500

250W 4 ohms 130W 8 ohms NC250

Class of operation Class D
Minimum load 2 ohms
Distortion 10Hz to 20kHz 0.002%
Signal to noise ratio 124dB
Output impedance 2.6 mohms
Peak output current 27 amperes
Damping factor >1000
CMRR 71dB
Power consumption 650W
Input voltage 240V/50Hz
Output connectors WBT binding posts
Input connectors Balance RCA or XLR
Input impedance 47Kohms
Size 210W x 290D x 80H (mm)
Weight 2.2Kg

Robson MB2 - Image Gallery


Robson MB1

Robson MB1

Robson Acoustics new Monoblock MB1 amplifiers represents the latest in high efficiency class D amplification and the beauty of hand crafted solid hardwood cabinets.

The first of a range of products following our love of natural materials and design approach to compliment our tube Pre-amplifier, Phono stage and our range of speakers.

Able to dig out the minutest detail from recordings without the harshness or fatigue associated with many class D amplifiers.
Hearing is believing!

Capable of driving virtually any speaker with 500W’s of incredible dynamic and controlled power, low output impedance and optimised input stages.

Honed out of solid walnut to give both beauty and acoustic resonance control reducing the outside impact on the sound together with solid brass feet for vibration isolation. Walnut is well known for it’s textured and earthy tone and a great compliment to these amplifiers.

Fine solid silver wire is used for input and output connections with WBT binding posts for the ultimate retrieval of audio signal.

Optional input for balanced or single ended to eliminate switching and available on customer request where Lundahl transformers are used to isolate and match other equipment.

  • Acoustic tonewood cabinets
  • Low standby consumption
  • High input impedance
  • WBT pole connectors
  • Solid silver wiring
  • Huge damping factor

PRICE   £4999.00/PAIR

Specification

Output power 500W 4 ohms 270W 8 ohms
Class of operation Class D
Minimum load 2 ohms
Distortion 10Hz to 20kHz 0.002%
Signal to noise ratio 124dB
Output impedance 2.6 mohms
Peak output current 27 amperes
Damping factor >1000
CMRR 71dB
Power consumption 650W
Input voltage 240V/50Hz
Output connectors WBT binding posts
Input connectors Balance RCA or XLR
Input impedance 47Kohms
Size 250W x 250H x 170H (mm)
Weight 7Kg

Robson MB1 - Image Gallery